bjornebraten
Active Member
- Posts
- 196
Have rumble . Think it`s from front. Maybe a wheel bearing. Km. is 170000 or 100000 miles about. Is it much work fitting a complete hub with bearing?
L322 rumble ,wheel bearing?
- Thread starter bjornebraten
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
ukadamwest
Well-Known Member
- Posts
- 2,990
- Location
- Surrey
Depends how corroded bolts are. i just had my cv gaiters inner and outer done for £80 a side. at that price it wasn't worth me getting the trolley jack, axle stands and big breaker bar out. the hub bolts have some big newtons on them!
- Posts
- 6,165
- Location
- North Manchester
+1 for the hub nut. Just did my cv boots and it took 3 of us to tighten it up. Wife with her foot on the brake, my son on the torque wrench and me pushing the socket on the nut with my foot.
All good fun though
All good fun though
bjornebraten
Active Member
- Posts
- 196
Will have car at a local garage tomorrow . Checkin bearinfs and cv joins. Had car for only 7 weeks. Sounds gettin louder.
bjornebraten
Active Member
- Posts
- 196
Cv joints and bearings ok. Will go to a specialist tomorrow, Let him take a round .
bjornebraten
Active Member
- Posts
- 196
have a feelin that it is possibly cv joint front.Maybe left side.
