Roof mounted aerial....
- Thread starter flex001
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 83,282
- Location
- Embasinga stocæ
are you and you family safe?
Why is it dangerous?
- Posts
- 83,282
- Location
- Embasinga stocæ
it is if you post in Landyzone International Rescue, when it isnt life threatening
Sorry I've put it in the wrong placeit is if you post in Landyzone International Rescue, when it isnt life threatening
- Posts
- 83,282
- Location
- Embasinga stocæ
yu did, but some kind person moved itSorry I've put it in the wrong place
coolyu did, but some kind person moved it
Tonyj66
Active Member
- Posts
- 255
- Location
- Stirlingshire
If I remember correctly, you remove the interior light and you should see the nut or bolt that holds it in place!
Thank you I'll have a look in the morning
teddywood1
Well-Known Member
- Posts
- 5,558
- Location
- stoke-on-trent
if you just want to take the antenna off then it unscrews from the base but you might need some pliers
I think the Base needs changing as it has tape over it
I had change mine when I got it. They are known to leak sometimes too.I think the Base needs changing as it has tape over it
4Bee4Bee
Well-Known Member
- Posts
- 322
- Location
- Shropshire
As Tony said, there is a nut that can be accessed by taking the interior light fixing off the bracket it is attached to.
If you need to replace the whole wire the roof lining does loosen off if you undo the visible bolts in the pillars and pull back the door seal.
Hopefully for just changing over the base you should be able to do it by just accessing the interior light hole though.
If you need to replace the whole wire the roof lining does loosen off if you undo the visible bolts in the pillars and pull back the door seal.
Hopefully for just changing over the base you should be able to do it by just accessing the interior light hole though.
I'll put some silicone under it and tighten it up
teddywood1
Well-Known Member
- Posts
- 5,558
- Location
- stoke-on-trent
My friend had that we cleaned the base after we took it off and then some silicon did the job but watch you do not over tighten it.
OK thank you for the advice...
