rocker/cam cover gasket
- Thread starter skinman
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Vissie
New Member
- Posts
- 673
- Location
- East Midlands
Gasket goes on dry, you can degrease the mating faces first if your so inclined.
bruno1926
Active Member
- Posts
- 118
Most definitely dry that's the idea of a gasket to take any irregularities between the mating surfaces. It's easy to put on and stays more or less in place when laying the cam cover on it
You could try nipping the bolts up a fraction, they have been known to be left a bit loose from the factory on occasion. As said above, the new gasket goes on dry. Provided both surfaces are clean and dry that should be job jobbed. Oh don't over tighten the bolts 
tina2709
Well-Known Member
- Posts
- 6,063
- Location
- mostly on my street
Hi did u do it and was it easy? I got a new one for mine but not attempted it yet
Vissie
New Member
- Posts
- 673
- Location
- East Midlands
Very easy job.
Only requires an 8mil on a quarter drive iirc and a rag.
Only requires an 8mil on a quarter drive iirc and a rag.
very easy indeed , and stopped oil leak in to plug
tina2709
Well-Known Member
- Posts
- 6,063
- Location
- mostly on my street
Cheers shall attempt mine at wk end if its dry
smnbyt
Active Member
- Posts
- 301
- Location
- Winchester, Hampshire
8Nm....
Similar threads
