SimonBrown
Active Member
- Posts
- 85
On the heater box there are 6 rivets that are tight into the joint:
Its just too tight for the nose of the lazy tongs.
I have Googled a bit and not really turned up anything that looks like it with cope with this or a few spots where some 4.8mm rivets need to go elsewhere.
Anyone got a recommendation for tooling? Ideally something tested/used/abused in real life.
Its just too tight for the nose of the lazy tongs.
I have Googled a bit and not really turned up anything that looks like it with cope with this or a few spots where some 4.8mm rivets need to go elsewhere.
Anyone got a recommendation for tooling? Ideally something tested/used/abused in real life.
