Rivet snap tool, anyone used them

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
wickford90

wickford90

Well-Known Member
Posts
3,623
Location
wickford essex
Been looking at snap tool to refit bonnet frame, can't find any info on how too use them don't really want to use pop rivets any info would be a big help
 
Use the inverted dome tool on the outside, insert the rivet into a countersunk hole( all sides of holes - gives more grip) then using a small hammer on the protuding section work in circular motion to peen it fully down, once tight heat anneal as it will crack in use without doing that
 
it does take a lot of practice to get them right and a fair amount of force against the blow of the hammer - try before commiting to the correct fitment on the bonnet, the last body I made took over 1,500 snap rivets !!
 
bmp42 said:
Use the inverted dome tool on the outside, insert the rivet into a countersunk hole( all sides of holes - gives more grip) then using a small hammer on the protuding section work in circular motion to peen it fully down, once tight heat anneal as it will crack in use without doing that
Click to expand...

thanks I assumed that was the method, didn't realise about the annealing bit.
 
I did the bonnet on mine, I actually took the frame out to save weight and like you didn't want pop rivets. It was a straight forward job the hardest part was holding the bonnet and reaching both sides, I put the snap in the vice pointing up and rested the bonnet on it then hammered the inside. The snap and rivets were of ebay.

 
You must log in or register to reply here.

Similar threads

L
Black & Decker BD 195/6 compressor
Replies
0
Views
591
lrmonks
L
S
seat backs questions
Replies
8
Views
570
grewth
G
gold rover
L322 Acorn Autoparts. Anyone used them?
Replies
2
Views
740
gold rover
gold rover
styleruk
Another A frame towing question
Replies
9
Views
1K
MrF
M
cornishboater
P38A HEVAC
2
Replies
35
Views
2K
pwood999
pwood999
Back
Top