RangeRoller dt
Well-Sprung Member
- Posts
- 14,393
- Location
- Trapped inside my head @ LZ asylum
Sounds like it’s all ‘working’ just gone a bit crazy 
ride height settings p38a
- Thread starter zoarial
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
The eas programme reads 147 for both sides and being a senile old bugger I cannot find these white connectors can somebody point me in the direction of a photograph of these connectors.
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
Assuming your car is RHD, passenger side footwell at the base of the A post between the bottom of the dash and the floor, plastic panel held by screws, remove it and the connectors are clipped to the metalwork. I'll have a look if I have some photo's
Two photo's, one of the connectors, the other after I removed them:-
Last edited:
Thankyou sir I have just received the refurb kit for the compressor and valve block so I will be sorting those components out in the very near future.
- Posts
- 2,427
- Location
- Isle Sheppy
I've your doin the valve block make sure you follow wammers eas tec section there's a good link on there
ovalandrover
Well-Known Member
- Posts
- 1,610
when u refurb the valve block make sure the solenoids are correctly wired or you will gwt some strange results like the front down and back up or one side up nd one side down. you can also get some manual inflation valves and see if there is an airbag leak. also make sure the air pipes from the valve block are in the correct position.
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
