Reversing sensor stopped working - any ideas?
- Thread starter Buel10
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 3,878
- Location
- Near Heathrow.
Probably best to start at the back !!
.
.
.
.
.
.
.
.
.
Depends on the car. My son has them on his FL1 TD4, but they never worked properly. When we had to replace the bumper, we cleaned up all the wiring. If I remeber correctly they worked a bit better, but only 3 out of 4 working. Generally they get full of water & road dirt, hence stop working (ultrasound doesn't go well through dirt !)
.
.
.
.
.
.
.
.
.
Depends on the car. My son has them on his FL1 TD4, but they never worked properly. When we had to replace the bumper, we cleaned up all the wiring. If I remeber correctly they worked a bit better, but only 3 out of 4 working. Generally they get full of water & road dirt, hence stop working (ultrasound doesn't go well through dirt !)
What are the symptoms? If there's a beep when the ignition is turned on, then the system has registered a fault. A quick diagnostic will point you to the cause, but it's likely a sensor or the harness connector between car harness and the bumper harness, which gets all the spray from the RH rear wheel.
