oldduffer
Active Member
- Posts
- 88
- Location
- Beverley East Yorkshire
Hi ever one not been on for quite awhile I’m getting a bit older but still got my old 2005 RR v8 still on road
don’t drive it much now but as usual has to have mot my last mot couple of advises of front brake flexes and ace boot
decided to get down to it whilst it’s warm. Anyway less of the chit chat and down to business,done brake hoses
and as per manual want to remove drive shaft from hub followed manual to the letter got puller as referred to in
manual and pros seeded to attempt to pull off slimes ,that’s as far as I got it will not slide off the splines.
Right I have now removed full hub and it on the bench , with hub spline facing upwards sprayed with penetrating fluid and left over night put puller back on and st won’t slide off, can I put it in a press or will I do it damage ? According to the instructions should just push the cv joint out of hub , has any body done this and had same problem thanks in anticipation
of your replies Oldduffer
don’t drive it much now but as usual has to have mot my last mot couple of advises of front brake flexes and ace boot
decided to get down to it whilst it’s warm. Anyway less of the chit chat and down to business,done brake hoses
and as per manual want to remove drive shaft from hub followed manual to the letter got puller as referred to in
manual and pros seeded to attempt to pull off slimes ,that’s as far as I got it will not slide off the splines.
Right I have now removed full hub and it on the bench , with hub spline facing upwards sprayed with penetrating fluid and left over night put puller back on and st won’t slide off, can I put it in a press or will I do it damage ? According to the instructions should just push the cv joint out of hub , has any body done this and had same problem thanks in anticipation
of your replies Oldduffer
people say I’m lucky
