Replaced ABS Sensor

pete r · Aug 31, 2013

I have replaced the front offside ABS sensor on my 02 Discovery TD5 due to the wire being damaged.

Still got the 3 amigos, do I need to have them reset on a diagnostic tool or should they have been reset by the self test function when turning the ignition on?

diver · Aug 31, 2013

You'll need to get them reset.

sierrafery · Aug 31, 2013

IF there's no other problem and you fixed an ABS sensor related fault the warning must go away after you exceed 9.4mph without tester involved, see attachment, last paragraph if you dont believe me

pete r · Aug 31, 2013

Ok thanks for your help.

pete r · Aug 31, 2013

sierrafery said:
IF there's no other problem and you fixed an ABS sensor related fault the warning must go away after you exceed 9.4mph without tester involved, see attachment, last paragraph if you dont believe me

There's possibly another fault still then, as I have taken the car for a run a couple of times since.

sierrafery · Aug 31, 2013

or there was an intermittent fault which is considered permannent by the ECU and after you clear it the lamps will stay off...anyway you have to hook to diagnostics to make sure

pete r · Aug 31, 2013

Yes, thanks for your help I will have to get it booked in to the garage to get them cleared.

sierrafery · Aug 31, 2013

make sure you remember well the stored faults before they clear them cos it's possible that the lamps will come on again after a while...it used to happen with SVS failure

pete r · Aug 31, 2013

Will do.

Replaced ABS Sensor

pete r

New Member

diver

Active Member

sierrafery

Well-Known Member

Attachments

pete r

New Member

pete r

New Member

sierrafery

Well-Known Member

pete r

New Member

sierrafery

Well-Known Member

pete r

New Member

Similar threads