Renew all bolts on rebuild?
- Thread starter Sterob
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Shifty1962
Well-Known Member
- Posts
- 4,209
- Location
- The Winchester Club - Englandshire
If you are going to the time and trouble, not to mention expense, of replacing the crankshaft then why would you not change any critical bolts? For what they cost the peace of mind is worth every penny. Don't forget to locktite the oil pump drive sprocket bolt while you are in the there.
I have reused head bolts but it was because we were in the middle of nowhere and new bolts were not available - also it was a works motor and not my pride and joy. I'm not sure the big end and bearing bolts are stretch bolts but I may be wrong. I have reused them and had no issues. The important thing there is that the big ends are fracture fitted and you must be extremely careful not to mix them up or get them the wrong way round. They also need to be very clean before you fit them together.
I have reused head bolts but it was because we were in the middle of nowhere and new bolts were not available - also it was a works motor and not my pride and joy. I'm not sure the big end and bearing bolts are stretch bolts but I may be wrong. I have reused them and had no issues. The important thing there is that the big ends are fracture fitted and you must be extremely careful not to mix them up or get them the wrong way round. They also need to be very clean before you fit them together.
chris-the-gerbil
Well-Known Member
- Posts
- 994
- Location
- Leeds
If you are going to that trouble then as above as the guy says. Unless an unplanned failure, I'd always buy new head bolts, mains and big ends, and major suspension bolts and engine mounts. It's just not worth it and it also gives you new heads that have not been abused perhaps, or rusted for ten years perhaps in case they need undoing again...
raywin
Well-Known Member
- Posts
- 3,808
- Location
- North Yorkshire
Don't forget to give us some pictures as you go along.
ozzyboydeano
Well-Known Member
- Posts
- 843
what happened to the crank shaft did it spin a bearing or snap
sierrafery
Well-Known Member
- Posts
- 17,871
- Location
- Arad/Romania
As long as it's strechh bolt it's not supposed to be reused IMO
raywin
Well-Known Member
- Posts
- 3,808
- Location
- North Yorkshire
It's pretty standard to torque a bolt to 75 % of it's elastic limit so that it leaves a margin.
But the stretch bolts are pulled into a higher point so they must be replaced to work correctly.
But the stretch bolts are pulled into a higher point so they must be replaced to work correctly.
markomate2
Well-Known Member
- Posts
- 899
- Location
- Bedford and Tallinn
When I did mine, I renewed all bolts incl the sump bolts!
Bit OTT but they (genuine ones) were cheap as chips.
Make sure everything is spotless.
All the pics from my rebuild thread have gone, thanks to Photobucket, but they did show the re-assembly.
Follow RAVE for the procedure, incl adding a few strategic runs of RTV before the sump goes back on.
PS When you start up after your rebuild, allow the engine to gently warm up but dont allow it to sit idling for ages, there can be a risk of oil starvation.
Bit OTT but they (genuine ones) were cheap as chips.
Make sure everything is spotless.
All the pics from my rebuild thread have gone, thanks to Photobucket, but they did show the re-assembly.
Follow RAVE for the procedure, incl adding a few strategic runs of RTV before the sump goes back on.
PS When you start up after your rebuild, allow the engine to gently warm up but dont allow it to sit idling for ages, there can be a risk of oil starvation.
