removal of transfer box motor??

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
P

pshane

Member
Posts
26
hi all is there any set way to remove the transfer motor, i can get it out so far but not all the way, as iv read on here i need to clean it out and add some new grease as its stuck in low gear at the mo,:(
many thanks shane
 
i was reading on here that the grease goes hard and stops it from working as it should if not used often in low range,
 
pshane said:
i was reading on here that the grease goes hard and stops it from working as it should if not used often in low range,
Click to expand...


Did you read the thread correctly, are you sure they were not referring to the electric hi/lo sector motor, in which case you don't need to remove the transfer gearbox...
 
hi yes i read it correct, the hi / low motor drys up and they striped it down and cleaned it out, replaced the grease and worked as it should, as mine is stuck in low gear and wont go back into hi,iv no intention in removing the transfer box just the motor
 
stopover said:
You can see the grease that has gone hard and preventing the full rotation od the motor, clean off and add a small amount of new grease and refit. Motor should now go full travel and change ratios.

Click to expand...

Grease won't stop motor from turning. A bad connection on the contact block will.
 
hi i just got the motor out, will strip it tomorrow at work & fit after work,

I would like to thank you all for your help on this,
many thanks shane
 
hi striped the motor and changed the grease and marked it up before striping down, refitted motor with no change, still in low, i did notice that the selector lights are flashing ? iv changed the ECU as it blow just before it went into low,
anyone have any ideas please
 
pshane said:
hi striped the motor and changed the grease and marked it up before striping down, refitted motor with no change, still in low, i did notice that the selector lights are flashing ? iv changed the ECU as it blow just before it went into low,
anyone have any ideas please
Click to expand...

When you had the motor off did you try to turn the shaft that comes out of the t/box to see if you can manually put the box in high ? It should move very easily, if it does not then perhaps the motor is ok and the problem is in the t/box. You can bench test the motor to see if it is functioning.:)
 
pshane said:
hi yes when i was putting it back in i did test the shaft and moves ok,
Click to expand...

Try the motor on the bench. If you don't use low range then turn the shaft to high then lock it in place by refitting the motor ( not in its original position obviously) till you get a motor that works. If you were closer I have a spare you could have tried:)
 
ok i will give that a go tomorrow after work,no i don't use low range i take it the best way would be to turn the spline on the motor to move it round or take it off and move the spline round,
 
thank you tomcat it got me thinking, i got wet but very happy all done and 2wd back
are you near dover kent
 
You must log in or register to reply here.

Similar threads

T
Auto Box Wont stay in Gear
Replies
11
Views
407
Graculus
Graculus
stoney424
What colour speedo drive gear should I be using?
Replies
3
Views
429
miktdish
miktdish
pwood999
P38A HEVAC Blend Motor Testing
Replies
9
Views
731
Datatek
Datatek
G
P38 4.0 v8 Automatic goes into low range all on its own
Replies
9
Views
1K
Datatek
Datatek
S
Transfer box removal
Replies
8
Views
844
dag019
dag019
Back
Top