Rear discs and pads

Hi Everyone

About to do front n rear disc n pads on my Disco 2,where I think the fronts are going to be ok as have done them on my old 300 tdi not long ago,I have never done rears,a so called LANDIE MAN i know said there is a special tool to winde in the caliper piston?? Is this correct or could i use a small g-clamp and apply pressure to piston to move it?

Biggs

wind back tool is only needed on cailpers that use it as hand brake too ,just push piston back slowly

jamesmartin said:

wind back tool is only needed on cailpers that use it as hand brake too ,just push piston back slowly

Click to expand...

Thanks james
I can start the job now confident of success,anythink else to watch for?

no is easy job on disco 2 ,worth pulling slides out and copper greasing at same time ,g clamp is perfect