- Posts
- 22,901
- Location
- In the next Glen
Disco 1 Rear crossmember mounts
- Thread starter DiscoLyle
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Cheers I will have to do some investigating. I can ways cut down the new ones of i need to.
currymunster
Well-Known Member
- Posts
- 796
- Location
- Folkestone, Kent.
Good work.
I did my near side sill last summer.
Amazing what else pops up with it. Floor, wing. Inner wing.
I can post pics if you want to see?
Edit.
This is my post when I did it.
https://www.landyzone.co.uk/land-rover/oops-more-work.350211
I did my near side sill last summer.
Amazing what else pops up with it. Floor, wing. Inner wing.
I can post pics if you want to see?
Edit.
This is my post when I did it.
https://www.landyzone.co.uk/land-rover/oops-more-work.350211
Last edited:
- Posts
- 9,105
- Location
- Roaming the UK on assignments
My old ones I cut off/fell apart wer 55mm new ones from YRM matched exactly.
Has your motor seen the hot snot gun in the past and just been nailed together to get it through the test?
Has your motor seen the hot snot gun in the past and just been nailed together to get it through the test?
exactly my thoughts. I reckon it’s been stuck together/fcuked around with previously. Sorry haven’t messaged mine but will be same as Kev’s no doubt. I’ve been making carpets out of rubber lol
- Posts
- 9,105
- Location
- Roaming the UK on assignments
I've been looking at the interwebs looking for a new PAS pump that don't cost more than £175
I think it has buy the previous owner. Im trying to undo it all now
currymunster
Well-Known Member
- Posts
- 796
- Location
- Folkestone, Kent.
Measured mine... 55mm I'm afraid.
Are you sure the rust on the body bit hasn't just bubbled up and making it look less?
Just a thought.....
Are you sure the rust on the body bit hasn't just bubbled up and making it look less?
Just a thought.....
