Disco 2 rear calipers. How easy to change?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Usually when they say caliper is seized, they mean the piston is not moving which would imply that the seals would have perished too. You can easily check this out by lifting the wheel and pressing the brakes and see if it's holding. At least, this was the case with mine and I just replaced the pistons and the seals. I suggest you don't use BritPart here - I had bought Bearmach seals and foolishly BritPart pistons - it's just a metal tube, so nothing can go wrong or so I thought ! Well, they wouldn't fit in the caliper chamber and had to get them replaced with Bearmach. As for the flexi pipes, I personally don't like clamping them. Instead I stop the flow with a few layers of cling film wrapped around the neck of the reservoir and secured with elastic bands. It never fails to seal.
 
Being garaged on Thursday for welding.

This will cost money but needs to be done.

Done lots of other jobs myself
 
I am pretty nervy about repairing as I only have one car and nearest spares place is 3 miles away
 
Tried to replace my disks and pads yesterday,
Couldnt loosen the caliper bolts to get the disk out, sending it to garage as they are seized so not such an easy job!!!

Andy
 
You must log in or register to reply here.

Similar threads

L
Disco 3 (LR3) Rear differential swap
Replies
2
Views
342
LR-hobbs
L
Vtechjoe
How easy is it to change both the Valve seals and Piston Rings
Replies
3
Views
1K
300bhp/ton
300bhp/ton
archwayanimal
Rear corner chequer plate?
Replies
3
Views
566
Knappster
Knappster
M
Disco 3 (LR3) D3 Air Suspension front air valve blocK
Replies
0
Views
370
Matt Hyde
M
R
L322 4.4tdv8 change oil cooler
Replies
8
Views
403
roythebus
R
Back
Top