re fitting a engine!!!! aaarrgghhhhh
- Thread starter ribeye69
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
mikebeetle
New Member
- Posts
- 143
- Location
- Leicestershire
have you got the clutch lined up properly?
Smilemon
Member
- Posts
- 99
- Location
- Fairbanks, Alaska
Do you have the right bell housing?
clivees
Well-Known Member
- Posts
- 2,070
Try turning the engine over with a socket on the bottem pully.
Sometimes you need to line up the splines with the clutch plate.
Sometimes you need to line up the splines with the clutch plate.
FFS Heidi
Member
- Posts
- 79
- Location
- Moircy, Belgium
Yeah: what he said.
Codbasher
New Member
- Posts
- 493
- Location
- Treuddyn, North Wales
Have you got the series clutch so that it mates to the gearbox splines, did you check the clutch slid on the splines before assembly??
Is the engine in line with the gearbox shaft? trying to slide it on at a small angle can make it almost impossible to line up.
Take yer time, try and rush it and it will never go on, I know, ive had the tantrum.....
Wot everyone else says as well....
Is the engine in line with the gearbox shaft? trying to slide it on at a small angle can make it almost impossible to line up.
Take yer time, try and rush it and it will never go on, I know, ive had the tantrum.....
Wot everyone else says as well....
G-man
BBQ king
- Posts
- 12,065
- Location
- essex.... in the middle somewhere
have you removed the extra dowels and drilled out the 4 bottom holes for the studs?
