P38A Range P38 ABS/traction control problem

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
B

bigjay1000

New Member
Posts
2
Hi all, hoping for some advice please:
The P38 (v plate, 4.6 petrol) has thrown up the dreaded ABS failure message - both lights stay on and the message is traction failure.
I've had the codes read and it comes up with a failure on the front offside ABS sensor, but that one has been tested and works fine.
I'm suspecting the ABS pump, but thats a chunk of cash to spend to find that it's actually something else . . .
Somebody here must have experience of similar problems - help!
Cheers
John H
 
Next thing to do is check the adjustment of the brake light switch as that can affect the ABS and Traction control light
 
I wouldnt be surprised if it was ECU failure but need to check with a new genuine sensor first, I found aftermarket didnt work properly. What is the exact code? It wont just report that its a certain sensor, it will report what is actually wrong (short to another being a favorite) or high/low resistance etc.
 
ovalandrover said:
Next thing to do is check the adjustment of the brake light switch as that can affect the ABS and Traction control light
Click to expand...

I have that problem! After doing some work on the master cylinder I found when pedal released the brake lights stay on - the switch isn't getting pressed. Can't for the life of me find any way to adjust it and I don't think there's any play in the master cylinder on the other side (ie that affects pedal travel) so in the end I extended the switch with a bit of plastic and electric tape.

So whats a better way?

bigjay1000 - Hope you don't mind me piggybacking on your thread? Saves starting a new one. Cheers!
 
rasheed said:
I have that problem! After doing some work on the master cylinder I found when pedal released the brake lights stay on - the switch isn't getting pressed. Can't for the life of me find any way to adjust it and I don't think there's any play in the master cylinder on the other side (ie that affects pedal travel) so in the end I extended the switch with a bit of plastic and electric tape.

So whats a better way?

bigjay1000 - Hope you don't mind me piggybacking on your thread? Saves starting a new one. Cheers!
Click to expand...

Remove switch. Pull plunger out of switch. Push pedal down. Fit switch let pedal up.
 
You must log in or register to reply here.

Similar threads

N
P38 abs / traction fault.
Replies
4
Views
1K
Neil.ms
N
B
ABS Issue
Replies
14
Views
879
Bangerang1
B
MikeFl4
P38A ABS faults and codes
Replies
17
Views
3K
MikeFl4
MikeFl4
F
P38A 97 P38 Gems - EAS issue which seems to have expanded
2 3 4
Replies
79
Views
7K
Grrrrrr
Grrrrrr
BeerHunter
Intermittent Traction Control Kicking-In
Replies
5
Views
2K
BeerHunter
BeerHunter
Back
Top