Radiator bracket repair

Bern · Apr 17, 2019

On to the next problem!!!

The steel bracket around the radiator has come detatched from the copper header and base on one side of the radiator.

What's the best way to fix it, apart from that the radiator looks good so I'd like to fix it rather than buy another?

I thought about trying to solder it, but open to suggestions.

Cheers.

marjon · Apr 17, 2019

Sounds like that was originally soldered from your description, pic might help.

But if that is the case then yes I would go with the solder option.

J

Bern · Apr 17, 2019

Looks like it was originally soldered:

Bobsticle · Apr 17, 2019

If it was soldered it would be silver and look like it had flowed without the bubbles. Same with brazing but yellow.
That looks like a later bodge with epoxy.
I dunt know the answer but probably either brazed or spot welded.

marjon · Apr 17, 2019

As^^^
Looks like a later repair(bodge).

That stuff needs to come off either way before you decide what way to go.

J

Bern · Apr 17, 2019

Maybe it's that chemical metal stuff. I'll clean it off and then try soldering it. I guess brazing would be better, but I've only got a small plumbing blowlamp.

tottot · Apr 17, 2019

Solder is the usual way, your blowlamp should be fine. Leaded solder if you can get some and a good flux.

steve2286w · Apr 17, 2019

I’d be wary of putting too much heat in and melting the solder on other side holding fins in. I’d do the expoxy type repair

rob1miles · Apr 17, 2019

Its soldered but you need to be careful. Get it very clean, acid flux and lead solder. A big blowlanp as it will soak up heat and have a water spray bottle to chill the bits you don't want melting. I would also wire the core and end cap just in case, then if the solder melts a bit it won't fall apart. I've soldered a a few radiators and repaired drain plugs and conenctions, its OK but you need to get the heat in fast, do it and stop before the heat soaks to places you don't want to melt. If the flame is too small by the time the bit you want to melt does everything esle is ready to melt too.

Blackburn · Apr 18, 2019

I would try tiger seal as long as you can clamp it in place long enough to allow it to set.

Bern · Apr 18, 2019

Blackburn said:
I would try tiger seal as long as you can clamp it in place long enough to allow it to set.

That sounds safer, will it stand up to the heat though?

Land Raver · Apr 18, 2019

JB Weld will be fit for purpose. Withstands very high temps.

Bern · Apr 19, 2019

Nice, I have some JB Weld somewhere!

Bobsticle · Apr 21, 2019

It may be fixed before the fins are soldered into place so heat wouldn’t be a factor when manufactured.
I’d go with adhesive of some sort but clean it to bare metal and provide a key.

Radiator bracket repair

Bern

Member

marjon

Well-Known Member

Bern

Member

Bobsticle

De Villes Advocaat

marjon

Well-Known Member

Bern

Member

tottot

Well-Known Member

steve2286w

Well-Known Member

rob1miles

Well-Known Member

Blackburn

Well-Known Member

Bern

Member

Land Raver

Well-Known Member

Bern

Member

Bobsticle

De Villes Advocaat

Similar threads