Puma bulkhead and dash onto 80's nintey?
- Thread starter 90maniac
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Thor1950
Well-Known Member
- Posts
- 39,238
- Location
- Land of the midnight sun
Why wouldn't it
Dr_evil
Banned
- Posts
- 29,535
- Location
- Perched on the naughty step
speedo is leccy and cable in puma isn't it instead of just a straight cable drive
Thor1950
Well-Known Member
- Posts
- 39,238
- Location
- Land of the midnight sun
just a sending unit and wire, not hard to do. should not be a problem. If they can build a little car and drive it on the moon, than this is a piece of cake. Be cheaper than getting a V8 running
Thor1950
Well-Known Member
- Posts
- 39,238
- Location
- Land of the midnight sun
V8 is for Doc........ a LZ comedy sketch
You will be fine just do it right and get the different bits you need.
In yank land lots of peeps have changed to digital gauges so should not be a problem. Just do a search (To locate what you need on inter web) and have the money and you can do anything
Does your V8 run??????????? might want to give Doc some advice not the other way around
ound:ound:ound:Thor1950
Well-Known Member
- Posts
- 39,238
- Location
- Land of the midnight sun
vegari
Active Member
- Posts
- 385
- Location
- Llanwrda, Dyfed
As I units and it, the puma dash protrudes so far that you won't be able to change gear.
As for dials, if you can make dash work just have a panel cut to fit in binacle and fit your current dial in that
As for dials, if you can make dash work just have a panel cut to fit in binacle and fit your current dial in that
