Problem with new clutch

lynall said:

Think bush fits into end of crank and not flywheel.
Lr garage would know that, general car place maybe not, in fact i dont even know what normal cars have in the way of a spigot bush?

Click to expand...

We machined one up for a '64 Ford Corsair ...

Well, they are going to take it apart again and have a look at it.
I assume that if it’s making a noise as you engage the clutch, they forgot to oil it or it’s a dud bearing and it won’t go OK on it’s own.

lightning said:

Well, they are going to take it apart again and have a look at it.
I assume that if it’s making a noise as you engage the clutch, they forgot to oil it or it’s a dud bearing and it won’t go OK on it’s own.

Click to expand...

In my experience they tend to get worse, but mine was noisy for many months and did not cause any serious problems.
But if the input shaft is flopping around then it cant be good for the gearbox input bearing.

I knew someone who destroyed his Morris Minor gearbox by neglecting to put a bush in. On the BMC A series I can't remember whether it goes in the flywheel or directly into the crank.

Back in the days when we had our Series 2 forward control we acquired some billets of phosphor bronze from a stall at Beaulieu autojumble. Combined with a small vintage Myford lathe this was very useful. We made the bush we've just been talking about, plus a larger top hat shaped bush that formed part of the clutch release mechanism, which apparently you couldn't buy any longer.

It's funny stuff to turn. It starts out peeling away like any other non-ferrous work piece, then all of a sudden decides it's a bearing and won't play any more, and the lathe starts vibrating and the tool starts smoking.