Part Identification

TeddyBS · Sep 11, 2020

Apologies for the probably dumb question... What is the part in the picture with the holes in called?

I tried looking for it on lrworkshop but couldnt find it?

Easy enough to replace i assume? Looks like 2 bolts...

tottot · Sep 11, 2020

Tub body stay.

Flossie · Sep 11, 2020

Rear wing stay.

Flossie · Sep 11, 2020

You can make new ones like I did for the 109 I used to have. 15 or 22mm copper pipe, flatten the ends and bend the flat bits to the required angle, drill and bolt on.
I'm tight

v8250 · Sep 11, 2020

or buy properly good quality rear wing stays from the ever superb, YRM - buy a pair with st/st bolts...it's a 10min job, both sides done

https://yrmit.co.uk/product/rear-wing-stay-land-rover-defender-90/

Flossie · Sep 12, 2020

£32

plus postage

.
1 MTR of flat alloy bar on eBay, same spec, £8.50 free p and p.
Knock a couple up in 20mins for 1/4 of the cost.
I'm careful not to open my wallet often

.
I notice the 90 ones are a different shape to the 109/110 ones so not so easy to make out of copper tube .

Al2O3 · Sep 13, 2020

v8250 said:
or buy properly good quality rear wing stays from the ever superb, YRM - buy a pair with st/st bolts...it's a 10min job, both sides done

https://yrmit.co.uk/product/rear-wing-stay-land-rover-defender-90/

I used these for my rebuild. Does a solid job and well worth it. And I’m canny tight! Not as tight as Flossie though!

Part Identification

TeddyBS

Member

Attachments

tottot

Well-Known Member

Flossie

Well-Known Member

Flossie

Well-Known Member

v8250

Well-Known Member

Flossie

Well-Known Member

Al2O3

Well-Known Member

Similar threads