P38A Part and pert number help
- Thread starter Dopey
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
Go on give us a clue,engine? fuel?cooling?metal? rubber?plastic?
- Posts
- 68,233
- Location
- The Wooly Witch
ABS ?
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
Good point, WHICH FECKING BLOCK.
The black plastic pipes that come out of the esa block valve
wont let me load the pic its these
http://www.rangerovers.net/forum/7-range-rover-mark-ii-p38/17338-eas-box-its-map.html
wont let me load the pic its these
http://www.rangerovers.net/forum/7-range-rover-mark-ii-p38/17338-eas-box-its-map.html
Good point, WHICH FECKING BLOCK.
Dont swear, you know im sensitive and vulnerable...
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
See if you can find anything here, then you might get the part number from the diagrams.
http://www.allbrit.de/NAV.cfm?PAGE=563917&SPRACHE=EN
Cheers
http://www.allbrit.de/NAV.cfm?PAGE=563917&SPRACHE=EN
Cheers
- Posts
- 2,101
- Location
- Mull of Kintyre
If its the piping for going to the air bags then just get a gi huge length from the bay. 8mm rings a bell
- Posts
- 2,101
- Location
- Mull of Kintyre
Make sure that when you cut it you cut it square and a pencil sharpener to chamfer it a wee bit. Don't cut it with a knife
There's also a company in Bolton and a guy called Andy who is superb for buying it from but when I remember the company name will let you know
There's also a company in Bolton and a guy called Andy who is superb for buying it from but when I remember the company name will let you know
myfirstl322
Well-Known Member
- Posts
- 41,354
- Location
- Hoots mon...
If you need to bent it, you just apply a little heat to it I think? dont you?
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
I didn't ****ing swear .
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
I made a former out of wood so that the pipe is held in shape while it cools. If you had told us what block in your first post I could have advised you and posted a photo but it's too dark and scary to go out to my garage now.
- Posts
- 2,101
- Location
- Mull of Kintyre
I just used a long enough bit to allow a long radius curve
- Posts
- 2,101
- Location
- Mull of Kintyre
I think it was Context supplies tel 01204 380988
Similar threads
Freelander 1
PG1 5th gear synchro spring
