P38DSE Temperature sensitive EAS

allanw · Aug 11, 2016

Since refurbing compressor eas has been working well. Levelling straight away after start up, rising and lowering on command etc. However yesterday morning the outside temperature had dropped to 8c and on start up eas was very slow to level, i.e. in raising rear suspension as car sits down a little overnight. Throughout the Winter months had the same problem but was hoping it was cured by compressor refurb. It seems to be it doesn't like the cold? Anyone else had a similar fault that they cured?

N2O · Aug 12, 2016

Start with draining water from air tank.

wammers · Aug 12, 2016

And fit a new drier.

allanw · Aug 13, 2016

Thanks fellows. My son removed drain plug from tank this morning and bone dry. Opened up dryer and same. Put desiccant granules in the oven for half an hour before refitting. Moisture in system was my thinking too in the winter months but the other day outside temp only dropped to 8c.

wammers · Aug 13, 2016

allanw said:
Thanks fellows. My son removed drain plug from tank this morning and bone dry. Opened up dryer and same. Put desiccant granules in the oven for half an hour before refitting. Moisture in system was my thinking too in the winter months but the other day outside temp only dropped to 8c.

You may have leaking NRV 1 on the pressure side. It won't go anywhere if the tank pressure is lower than the pressure in the bags.

tomcat59alan · Aug 13, 2016

Was there any white powder in the bottom the dryer? Take the exhaust filter off the valve block and see if any has been injested. That will cause problems with the valves seating correctly

allanw · Aug 14, 2016

Yes there was residue in the bottom. Will check it out thanks. Non return valve makes sense too. Thanks.

tomcat59alan · Aug 14, 2016

allanw said:
Yes there was residue in the bottom. Will check it out thanks. Non return valve makes sense too. Thanks.

The NRV's are in the valve block so the residue may be causing problem's in the v/block. Sound's like a strip down, clean and "O" ring replacement may be on the cards.

allanw · Aug 14, 2016

Job for next weekend. Still wondering why it should be temperature related. Nitrile O-rings have a huge temperature range as do rubber, Viton, neoprene, polyurethane etc. they should function correctly down to -50c. but who knows what Land Rover uses? Anybody know what the airbags are made of specifically?

wammers · Aug 14, 2016

allanw said:
Job for next weekend. Still wondering why it should be temperature related. Nitrile O-rings have a huge temperature range as do rubber, Viton, neoprene, polyurethane etc. they should function correctly down to -50c. but who knows what Land Rover uses? Anybody know what the airbags are made of specifically?

Not if they are coated with crusted on silica gel dust.

P38DSE Temperature sensitive EAS

allanw

Active Member

N2O

Active Member

wammers

No longer with us, RIP

allanw

Active Member

wammers

No longer with us, RIP

tomcat59alan

Well-Known Member

allanw

Active Member

tomcat59alan

Well-Known Member

allanw

Active Member

wammers

No longer with us, RIP

Similar threads