P38 transfer box

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

matcossy

New Member
Posts
23
hi i think my transfer box has locked up!
what would course this and how can i fix it???

please help

regards matt
 
What makes you think your transfer box has locked up?
 
well when i turn tight corners lets say right i have to give it more throttle at slow speed as it feel like the brake is on and the rear drivers wheel skids forward,

i also jack up the front axle and tryed to turn wheel with a knocle bar but it will not turn..
so what do you think?

regards matt

o i would like to say this is my first p38..
 
Sounds like you're running it with the centre diff lock on .. not a good thing .. ;)

It could be that or stuck UJ's etc .. whereabouts are you?
 
jack one front wheel up try turing it with a long bar and socket on a wheel nut it should turn slowly/stiffly if it wont turnviscous coupling is seized, it sits in a housing just behind front prop on t/box can be changed without removing t/box google rtc6044
 
Sorry, I still drive a 'normal' Landy .. didn't know they had VC's .. ;)

I suppose (hope) it does a similar job as a CDL but progressively maybe? Used to have a viscous drive on a racing (Radio Control) Monster Truck many years ago .. :)
 
hhi iv done the jack up one wheel and tryed to turn it but no luck at all....
what would coures it to seize up like this? its not noisey or anything,
is it possible to unseize??
is this a common thing to happan to these??

im in derby

regards matt
 
hhi iv done the jack up one wheel and tryed to turn it but no luck at all....
what would coures it to seize up like this? its not noisey or anything,
is it possible to unseize??
is this a common thing to happan to these??

im in derby

regards matt
they dont last forever ,10 years roughly on the classic model ,you can get recon ones from places like ashcroft transmissions i believe,you can remove front prop for the time been to stop the wind up buggering front diff
 
is there any diffrence between the years and models when it come to getting a replacement?
and can this be change over on my drive?

regards matt
 
am i right in thinking that where the front prop bolts up to is the bit i need to i need to take apart to get the lsd out??

sorry for being abit simple

regards matt
 
ok that looks easy to do ill get one orded tomorrow,,,
is there anything i need to no upon installing it?

regards matt
 
no ,you will just need some silicone sealant ,if you look around the edge of housing you will find tabs to lever against to remove it ,sealant sticks it well usually,once youve removed flange v/c will press or tap out of housing
 
no ,you will just need some silicone sealant ,if you look around the edge of housing you will find tabs to lever against to remove it ,sealant sticks it well usually,once youve removed flange v/c will press or tap out of housing
spray brake cleaner to clean faces
 
Back
Top