P38, No glow plug light but glow plugs are getting power

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Colleydog91

Member
Posts
36
Location
Coventry
Hi my p38 no longer brings on the flow plug light, when I turn ignition on the relay clicks and I have power at the plugs.. but no light on dash, the light does work though as I can bring it on using nanocom.
 
There is a great big maxi fuse 80a iirc in the engine ecu housing behind the battery it looks like a flat bit of metal have a check of that.
 
Here is a pic of a blown one
15905990006177752918474440247682-jpg.210548
 
Looks like connection from bcem is good as I can force the light on using nanocom, its weird
Unless connection from engine ECU to bcem
 
Hi I will check the connectors, I have recently fitted another engine so that connector under the expansion tank has been unplugged and re plugged however the light was working straight after the engine change and stopped working a few days after.
I think the temperature sensor is OK as it does bring the plugs on just not the light.
 
I will check all the pins in the big plug under the expansion tank tomorrow, that's the only one that had been disturbed, I take it I need to disconnect the battery again before I mess with it?
 
Back
Top