P38 key fob

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Rubberknees

Rubberknees

Well-Known Member
Full Member
Posts
4,655
Location
Rotherham
I have 2 working key fobs. One I use regular and the other twice a week . The one I only use twice has over the past 6 mnths flattened one of the batteries in the fob. The first time I put down to dodgy batteries and replaced, these were Duracell. The second time panasonic, same thing happened. Then Ever Ready then some off the bay I've never even heard of the make. The longest the fob has last has been about 6 weeks. Saturday I put new batteries in and have used it daily and today message on dash low key fob battery again. On testing one battery again nearly flat. This is always the battery that is nearest the board. I have tried cleaning the fob out with electrical cleaner, no difference. This fob was repaired several years back by some one we all know and trust and has been fine until these past months or so.
Any one got any clues or ideas for what could be causing it. Its really weird it is only one battery that goes flat and not both

I thank you
 
the batteries are stacked, in parallel. unless there is an intermittent short i dont see whats going on.. once is a duff battery, twice is unlucky.. i dont believe in coincidence
 
@Rubberknees It's odd that only one battery goes flat. The batteries fit inside the cover, there is a metal strip the connects the positive of the battery furthest into the cap to the PCB. Looking at one of mine, if that metal strip is loose, it's just possible it may cause a short. As only one battery goes flat, that would seem to rule out a fault on the PCB.
 
Datatek said:
@Rubberknees It's odd that only one battery goes flat. The batteries fit inside the cover, there is a metal strip the connects the positive of the battery furthest into the cap to the PCB. Looking at one of mine, if that metal strip is loose, it's just possible it may cause a short. As only one battery goes flat, that would seem to rule out a fault on the PCB.
Click to expand...
If you remember you sent me a replacement strip as mine broke in two. This is whats in and it looks OK compared to my other fob. Whether its not seated properly I don't know. I'll take it out and refit, see if that does any thing
 
Right update time. Same batteries now been in for 2 weeks and still working. Both batteries showing 3.1 volts on multimeter so fingers crossed.
One pointer whilst battery holder out of fob shone a light on it and went over with magnifying glass. Have found a tiny piece of metal embedded in the battery holder where one battery would touch it. Could this be the reason only 1 battery drained. Have taken tape off just to see and will feed back :)
 
Rubberknees said:
Right update time. Same batteries now been in for 2 weeks and still working. Both batteries showing 3.1 volts on multimeter so fingers crossed.
One pointer whilst battery holder out of fob shone a light on it and went over with magnifying glass. Have found a tiny piece of metal embedded in the battery holder where one battery would touch it. Could this be the reason only 1 battery drained. Have taken tape off just to see and will feed back :)
Click to expand...
I would have left the tape on. :)
 
You must log in or register to reply here.

Similar threads

DollyBird
Extra fob battery connector?
Replies
1
Views
298
doriz
doriz
Ola66
L322 2007 Vogue SE 3.6TDV8 Doesn't recognise key fob, can't turn key in ignition or turn off alarm!
Replies
5
Views
803
Graculus
Graculus
D
Key fob
Replies
0
Views
491
DAVID HICKIE
D
F
Disco 1 Immobiliser issues
Replies
11
Views
2K
discool
discool
nevillen
Key fob not functioning after battery change
Replies
7
Views
1K
nevillen
nevillen
Back
Top