Does anyone know if any extended brake hose kits are available for the late p38's I ordered one kit that was for all models but they only fit up to 1996 and the rears are done in two halfs per side and mine is a longer single Flexi each side ?
P38 extended brake hoses
- Thread starter Bern768
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
brianp38dse
Well-Known Member
- Posts
- 20,011
- Location
- heathrow
300bhp/ton
Well-Known Member
- Posts
- 4,998
- Location
- Near MK
https://www.jgs4x4.co.uk/range-rover-p38-2-extended-brake-hose-kit-goodridge/
Or you can use the fronts from the 'other' kit (Britpart I assume). They are a bit long, but can be used on the rear if you secure them. Then get some more fronts for the front.
Or you can use the fronts from the 'other' kit (Britpart I assume). They are a bit long, but can be used on the rear if you secure them. Then get some more fronts for the front.
300bhp/ton
Well-Known Member
- Posts
- 4,998
- Location
- Near MK
In fact, I wonder if you could use a standard front line on the rear....
brianp38dse
Well-Known Member
- Posts
- 20,011
- Location
- heathrow
If its different to the pic in the box someone has altered the set up
Flossie
Well-Known Member
- Posts
- 10,949
- Location
- Shropshire
You should have 4 flexi's at the rear, 2 short(about 6") and 2 long going to the calipers. The short ones are not obvious to see.
Sorry for the rather late reply been a rather hectic few days ,it is like the one in the box picture without the lines running across the axle , the problem I seem to have found is the old type extended kits are readily available but the one for the later set up is not,
