P38 emissions fail

Datatek · Mar 17, 2019

RangeRoller dt said:
It can leak anywhere between manifolds and tailpipe. If you put some washing up liquid and water in a spray container, spray it while vehicle is running (manifolds, joints , anywhere and everywhere) you will easily see the bubbles at a leak

Or steam

Ratae · Mar 17, 2019

Neil.ms said:
Didn’t actually get a print out of the emissions fail. I will give them a call on Monday and see if they still have it? I replaced the exhaust from the cat back and will check tomorrow that it is all tight ( if it has a leak downstream from the O2 sensors would that effect emissions?).

Did you use plenty of exhaust paste on the joints or just put them together dry & clamp up?

Neil.ms · Mar 17, 2019

Must admit it was raining cats and dogs when I dry fitted it, so I just clamped it all together! I will get under it again today and get the job done properly! ( must admit I thought as long as the exhaust was quiet that it was doing its job, didn’t realise it might have an effect on emissions).

ukadamwest · Mar 17, 2019

Ratae said:
Did you use plenty of exhaust paste on the joints or just put them together dry & clamp up?

oh I hate that paste. its mucky gets everywhere, doesn't seal well and a bugger to clean off.. I prefer to use heat resistant metal tape, wrap the joint slide the seal over and tube clamp

siddeley · Mar 17, 2019

Hi..02 sensors and cats....that was the prob with mine
Regards

P38 emissions fail

Datatek

Well-Known Member

Ratae

Well-Known Member

Neil.ms

Member

ukadamwest

Well-Known Member

siddeley

Member

Similar threads