Josh Wiggill
Member
- Posts
- 38
- Location
- Hereford
Yes I had been previously advised to steer well clear from the red ones as they are to small apparently
P38 EAS - Brass Compression Fitting Mod
- Thread starter Josh Wiggill
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Datatek
Well-Known Member
- Posts
- 44,819
- Location
- Near Poitiers SW France
They don't look too bad at all. So maybe the problem is in the valve block with the seating of the O rings.
If you remove the exhaust silencer rom the valve block, is there any trace of white powder?
Last edited:
Josh Wiggill
Member
- Posts
- 38
- Location
- Hereford
I had a closer inspection of the rear bags on the side facing the front of the car and they are just as cracked and perished as the fronts…they are also dated 2005
Datatek
Well-Known Member
- Posts
- 44,819
- Location
- Near Poitiers SW France
OK, time to change the bags. My guide is in the tech archive.I had a closer inspection of the rear bags on the side facing the front of the car and they are just as cracked and perished as the fronts…they are also dated 2005
- Posts
- 12,601
- Location
- Sud ouest France !
Pictures 6,7 and 8, the bags are finished. Any surface cracks means the rubber can't flex and has dried out. What you can't see I how they are inside. I'd change them.
Last edited:
Datatek
Well-Known Member
- Posts
- 44,819
- Location
- Near Poitiers SW France
I need to go to SpecsaversPictures 7 and 8, the bags are finished. Any surface cracks means the rubber can't flex and has dried out. What you can't see I how they are inside. I'd change them.
Similar threads
