Hi everyone, I'm selling my p38 dhse this week and wanted to take the psi power box off to first. Being a complete amateur please can anyone tell me if this is just a case of unplugging a connector? and is this a job even a muppet like me cant get wrong? Thanks in advance for any help
p38 diesel psi box removal advice.
- Thread starter sdb
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
rangiep38
New Member
- Posts
- 248
- Location
- Sunny Scotland
if its the same as the 1 i had it should just be in-line with the injector pump so should just have a t-piece to remove and then just plug the injector pump back in, there may also be a wire going to the engine ecu pin 37 just remove the wire and your done.
rangiep38
New Member
- Posts
- 248
- Location
- Sunny Scotland
It is an awkward little bugger and i was near giving up fitting it but removal seemed a bit easier and yes it would be best suited to someone with lady like hands so best to get the misses to do it!
