P38 diesel intank fuel pump

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
DM68

DM68

Active Member
Posts
246
Advice needed please,planning on changing mine soon so done the searches and been on fleebay and there is a huge difference in price for the fuel pumps,ranging from £50-£150. Now obviously i dont want a ****part one but can anyone recommend a supplier of a decent one,cheers
 
just had mine replaced, got it from island 4x4 they also dropped the tank and cleaned all the sludge out, as i want to make sure all was clean when they put the new pump in they took 2.5hours to do it?:)
 
This post shows how to replace the pump by cutting a hole in the floor rather than removing the tank. It is how I did mine and it is a lot easier than taking the tank out.
http://www.landyzone.co.uk/lz/f10/tank-fuel-pump-template-p38-109368.html
As far as the pump is concerned I would go for a landrover one. I bought a britpart one and it lasted 3 months. Got it replaced and I am now watching to see if it packs up again. I will report back to the forum.
 
Although i would agree that cutting a hole in the floor is alot easier to do, i opted for the dropping of the tank for several reasons,
1. I wanted to check all the fuel lines hiding under the tank,
2. I wanted the tank cleaned out before the new pump was put in to ensure no sludge and dirt was stucked up. (which was found in the tank)
3. Cutting the floor would weaken the floor and allow rusting and water to come in.
4. Cutting the floor......It's MONKEY!!
5. I'm a woman and it will be done my way, and wasn't me getting my hands dirty on this one!!!:D

:p
 
Thanks for replies, I am going hole in floor route and epoxy seal it, I,ll try Foundry 4x4 and hope its a decent bit of kit.
 
DM68 said:
Thanks for replies, I am going hole in floor route and epoxy seal it, I,ll try Foundry 4x4 and hope its a decent bit of kit.
Click to expand...

Think you will find that unless you get the genuine Land rover pump at £215.48 from a dealer like Rimmers. All the others. Famous 4 £120.00 + Vat. Foundry £81.95. Rimmer aftermarket £59.94. Island 4x4 £41.66 are all the same Britpart type item.
 
ladyranger said:
Although i would agree that cutting a hole in the floor is alot easier to do, i opted for the dropping of the tank for several reasons,
1. I wanted to check all the fuel lines hiding under the tank,
2. I wanted the tank cleaned out before the new pump was put in to ensure no sludge and dirt was stucked up. (which was found in the tank)
3. Cutting the floor would weaken the floor and allow rusting and water to come in.
4. Cutting the floor......It's MONKEY!!
5. I'm a woman and it will be done my way, and wasn't me getting my hands dirty on this one!!!:D

:p
Click to expand...

Good for you, a proper mechanic. Not a Roger the bodger. :):):)
 
You must log in or register to reply here.

Similar threads

stumpyj
(2000 TD5 90 defender)TD5 Fuel Pump
Replies
4
Views
338
stumpyj
stumpyj
DefendingLancashire
300TDI Four-parter: brake wear, lift pump / fuel filter, turbo, and bushes / squeaking
Replies
13
Views
502
miktdish
miktdish
M
high pressure fuel pump regulator possible issue after change
Replies
4
Views
1K
MGT
M
DollyBird
Engine disabled, keys not working, tried the guide “Re-synching the Range Rover P38 diesel engine with the Solved - BECM using a Nanocom” no luck
Replies
9
Views
1K
DollyBird
DollyBird
B
Noisy fuel pump and cutting out
Replies
7
Views
2K
firedamper
firedamper
Back
Top