tony worsley
Member
- Posts
- 55
Hi Would Anyone Happen To Have In Their Possession A Schematic Wiring Diagram For A 4.6 2000 Vogue . I Am Attempting To Repair My Ecu And Any Help Would Be Appreciated... Thanks Tony
P38 Diagram
- Thread starter tony worsley
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
O Bife
Active Member
- Posts
- 409
- Location
- Almada, Portugal
Hi,
Could they be in the Rave manuals?
If so and you don't have a copy I could send one off to you.
All the best,
Phil
Could they be in the Rave manuals?
If so and you don't have a copy I could send one off to you.
All the best,
Phil
tony worsley
Member
- Posts
- 55
thanks for that ,, i have purchased 1 off ebay now thanks
tony worsley
Member
- Posts
- 55
lol i find it hard to believe nobody on this webby knows the whereabouts of a schematic wiring diagram for the becm???
Irishrover
Well-Known Member
- Posts
- 5,317
- Location
- La Trimouille, Vienne, France
As far as I know, there is no schematic available for the BECM. As the outputs are controlled by Mosfets, it's just down to manually sorting the internal circuitry out. I have fitted new Mosfets in the past with success but without any schematics. All the Wiring diagrams on RAVE will show is the pin outs etc. to the BECM and the internal circuitry is "Hidden" to prevent people like us saving money. Diagnostic software such as Test Book or Rovacomlite "Direct Access" module will not give the logic details, only allowing programming of parameters and identifying faults.
Irishrover
Well-Known Member
- Posts
- 5,317
- Location
- La Trimouille, Vienne, France
Forgot to add that I have the Rovacomlite system and have been using it for about 5 years.
tony worsley
Member
- Posts
- 55
many thanks irishrover .. we have ironed out all faults now with the exception of the rear n/s window wont go up all rest are fine and the n/s rear will go down but not return . i have removed the motor and wired it out of the door and it still wont go up .from any of the 2 switches ..
Irishrover
Well-Known Member
- Posts
- 5,317
- Location
- La Trimouille, Vienne, France
Sounds like a motor fault then????
tony worsley
Member
- Posts
- 55
no i have wired the motor direct to bat pack and it works both ways
Irishrover
Well-Known Member
- Posts
- 5,317
- Location
- La Trimouille, Vienne, France
Check the power from the pin outs at the BECM then work your way back to the switch and to the motor plug. If it works when powered externally then either there is no output from the BECM or you have a switch/wiring fault.
