Bedfordrl
Member
- Posts
- 33
- Location
- Bordon,Hants
Hi, I have a 1983 Range Rover auto and have an overheating problem.
Recently she would get near the red zone if i was doing over sixty,so i didn't.
But on a recent low speed run in the snow she got hot ,now i also have a problem with the poppets which means i do not have a low tickover when warm,so how do i sort them out because i will have to sort out the idle speed before i have a fiddle with the timing.
On the timing side she sounds fine when in drive and pulls well and passes her emisions with flying colours.
She has an Aldon ignitor on board.
She has also started a habit of taking a while to start when turning over,sometimes only firing when the ignition key is released.
Erm, the only things i can add is that when warm the heaters blow warm constantly ,unlike when i had head gaskets go in the other Range Rover,which would blow cold when the gauge went into the red.
The water seems to be circulating so a presume the pump is ok.
The thermostat was binned ages ago.
I have done a search on this site and the idea of holding the fan with a hammer looks an interesting way of testing the viscous fan.
Any help would be very welcome.
Recently she would get near the red zone if i was doing over sixty,so i didn't.
But on a recent low speed run in the snow she got hot ,now i also have a problem with the poppets which means i do not have a low tickover when warm,so how do i sort them out because i will have to sort out the idle speed before i have a fiddle with the timing.
On the timing side she sounds fine when in drive and pulls well and passes her emisions with flying colours.
She has an Aldon ignitor on board.
She has also started a habit of taking a while to start when turning over,sometimes only firing when the ignition key is released.
Erm, the only things i can add is that when warm the heaters blow warm constantly ,unlike when i had head gaskets go in the other Range Rover,which would blow cold when the gauge went into the red.
The water seems to be circulating so a presume the pump is ok.
The thermostat was binned ages ago.
I have done a search on this site and the idea of holding the fan with a hammer looks an interesting way of testing the viscous fan.
Any help would be very welcome.