Oil filter parts not mentioned

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Have you removed the old filter? If so you should have found the washer plate and spring.
They are reused when fitting new filter as in post above.
 
tottot said:
Have you removed the old filter? If so you should have found the washer plate and spring.
They are reused when fitting new filter as in post above.
Click to expand...
I am about to, hope previous owner had it
boguing said:
Interesting problem - you're not supposed to lose them!

Put a wanted in the ad section, I'm sure someone will have a spare.
Click to expand...
To have them new (if someone's a control maniac) u need to buy yourself a new casing?
 
Ekenoos said:
I am about to, hope previous owner had it

To have them new (if someone's a control maniac) u need to buy yourself a new casing?
Click to expand...
I honestly have no idea, try calling anyone who has one in stock - although that's going to a challenge I'd guess. If you're hung up on new, consider that anything lurking on a shelf will almost certainly have been made in the same decade as yours, and the steel exactly the same day as the Big Bang.
 
IMG_20240803_114511.jpg
IMG_20240803_114506.jpg
IMG_20240803_114404.jpg

Just finished pulling this out

Am I missing the rubber washer filter bolt? Can you replace this with an rtv silicone like wurth
Also cant really see the upper ring seal.
Maybe explains why he was leaking in two parts 😂

Also the guy used a Mann filter is it good quality? Maybe I buy the next ones
 
A new filter should have come with a new upper seal and bolt washer. Think I can see the old ring in filter housing [ black line ] Seal can be quite hard after being squashed in there some time. Something with a point is usually needed to pick it out.
 
Boguing interesting, do you make your own rubber seals, I am interested in the future to be able to do that if you do have a guide of yours or someone else's

The new filter doesn't have the bolt washer so I ll order a few along with the copper sump washers
Tottot probably the black thing is a rlly cooked oil stain brother 😂 but will try again with a sharper screw driver or a knife

Is this housing that left on the engine block removable? Any videos? Would be good if you can remove it to inspect it and wash it
Nvm about that one I think I found from the workshop manual how to
 
Last edited:
You can buy lengths of different diameter nitrile rubber, cut to length and superglue together. Sounds sketchy but works perfectly. I've also got various thicknesses of nitrile rubber sheet.
 
You must log in or register to reply here.

Similar threads

Ekenoos
I am starting to think that servicing the ol landy is more of an adv than off roading it
Replies
7
Views
634
Ekenoos
Ekenoos
yfo866
Oil and filter change on 101 with the original V8
Replies
2
Views
2K
Rangieman123
Rangieman123
G
Coolant temperature sender Series 3 2.25 diesel question.
Replies
5
Views
1K
Guidoma
G
xDParis64
Freelander 1 Converting from wasted spark to distributor (or Visa Versa)
Replies
0
Views
359
xDParis64
xDParis64
newb
L322 DIY Full Service
Replies
9
Views
2K
Datatek
Datatek
Back
Top