busakaz
Active Member
- Posts
- 381
- Location
- Daventry,Northants
So how does the water get in normally.
obd problem
- Thread starter autogas
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Datatek
Well-Known Member
- Posts
- 44,884
- Location
- Near Poitiers SW France
From all the designed in leaks of course
:behindsofa:
autogas
New Member
- Posts
- 90
- Location
- Blaina Abertillery South wales Uk
pull a bung out of the floor unless your going to wade it , water comes in finds the lowest point and leaves
i owned fords in the 80's always had to drain the floor pans on them .
i owned fords in the 80's always had to drain the floor pans on them .
- Posts
- 16,479
errrr...is this your first Land Rover????
Most often it is from the Sunroof, the Ill fitting Door seals, the badly designed Tailgate Seal, the roof joints, the pretty much anywhere there is a join!
you name it it will leak and that includes the pipes to the heater!
busakaz
Active Member
- Posts
- 381
- Location
- Daventry,Northants
Yeh i had a mk1 escort and had to drill holes in it
- Posts
- 16,479
Yeh i had a mk1 escort and had to drill holes in it
:hysterically_laughi:hysterically_laughi
autogas
New Member
- Posts
- 90
- Location
- Blaina Abertillery South wales Uk
errrr...is this your first Land Rover????
Most often it is from the Sunroof, the Ill fitting Door seals, the badly designed Tailgate Seal, the roof joints, the pretty much anywhere there is a join!
you name it it will leak and that includes the pipes to the heater!
looks like any rover then saint , my MGZR leaked like a whore at a stag night , sealed the sunroof up and it was good , well apart from the new head gasket and modified cooling system that had to be done , well its a rover its expected .
what about a little petroleum jelly on all the electrical connections to help prevent corrosion is this a good thing . :behindsofa:
busakaz
Active Member
- Posts
- 381
- Location
- Daventry,Northants
May be a monster plaster aswell
rattler1975
New Member
- Posts
- 2
- Location
- Cincinnati, Ohio
Forgive my stupidity. I have searched the forums, web, and RAVE manual and still can't locate these plugs. I am have a similar problem and I am hopeful that maybe this may be my issue as well.
rattler1975
New Member
- Posts
- 2
- Location
- Cincinnati, Ohio
After a little digging I figured it out. For anyone else wondering, this connector is located on the drivers side behind the plastic housing that the hood release is encased in. Just lift the plastic cover for the foot rest and there is a single screw. Remove that and then the lever to release the hood and you'll see this connection.
