Number plate MOT

MR BFG · Jun 10, 2013

My 90 is almost ready for the MOT but before I take it to the test station on Wednesday could anyone tell me wether they think this will fail?
It looks like water has gotten between the acrylic layers in the rear plate.
http://www.flickr.com/photos/93654476@N07/9006348854/lightbox/

Cheers

Cabbie · Jun 10, 2013

Doubt if they'll fail that. My tester would put it down as an advisory.

Jongould · Jun 10, 2013

Its is still legible so will pass on that however I cant see in the picture if its still reflective, it looks like it is so it should pass no problem...

gse1986 · Jun 10, 2013

Looks fine to me. If it does fail, remember to take v5 when getting a new plate done

pussa13 · Jun 10, 2013

I think, for what it will cost shove another one on!

Trewey · Jun 10, 2013

advisory at most.

Shifty1962 · Jun 10, 2013

Mine would have failed its last MOT for delaminating rear plate. Luckily I had my trailer plate in the back of the motor so swapped them over while the tester took a leak. Manky plate is on my trailer as it don't need an MOT.

ratty · Jun 10, 2013

Shifty1962 said:
Mine would have failed its last MOT for delaminating rear plate. Luckily I had my trailer plate in the back of the motor so swapped them over while the tester took a leak. Manky plate is on my trailer as it don't need an MOT.

I keep a spare set of plates on board for MOT time. The good uns go on at the MOT station and then get taken back off again straight after. That way I have a spare set should mine get nicked (again) and I don't have to worry about em de-laminating.

MR BFG · Jun 10, 2013

ratty said:
I keep a spare set of plates on board for MOT time. The good uns go on at the MOT station and then get taken back off again straight after. That way I have a spare set should mine get nicked (again) and I don't have to worry about em de-laminating.

That isn't a bad idea, doubt it will arrive before Wednesday now if I order from fleabay. Was thinking of getting a stick on front plate for the vent anyway.

Thanks for all the input. 90 is now at the forge awaiting footwell and tranny tunnel welding before Wednesday.

Number plate MOT

MR BFG

Active Member

Cabbie

Well-Known Member

Jongould

New Member

gse1986

Active Member

pussa13

Active Member

Trewey

Cockernee, Pasty munchin bastid.

Shifty1962

Well-Known Member

ratty

I'm not special I'm limited edition

MR BFG

Active Member

Similar threads