P38A No power

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
P

palace

Active Member
Posts
739
hi all this was posted a while ago and the op never followed it up but it covers my exact problems can anyone help
Hi All ,I have a 1999 p38 4.0 lpg range rover thats got no power,things that i have done to try and cure problem:
new plugs and leads,new filters,new exhaust,new air flow meter,
the engine feels like its running on 6 pots ,on idle the engine sounds fine
when you rev engine it sound fine,when you select drive and pull away slow it feels normal then if you try to put your foot down it just builds up very slowly,there is no kick down punch when you floor it, I cant overtake a milk foat, Whats wrong with this beast?
 
Engine is 4000 miles old from turners we with high lift cams and gas flowed heads waste of money from new as far as I can tell
Anyone got any sensible suggestions ? As exhaust plugs and leads are new ?
 
See above! Unless its been decatted?

From reading your original post, it appears you have copied and pasted someone elses problems which are similar to your own, is that the case?

Have you actually changed the MAF? Checked for air leaks? Checked its got the correct spark plugs (what year is yours?)

Will it idle properly? And rev cleanly with no load?

You can quite crudely when its running remove a plug lead at a time and see what if any effect it has on the idle speed/sound/note. If you unplug a lead and there is no change it means that that cylinder is not firing for whatever reason.
 
Right sorry to take so long. Getting. Back to you l have a nano-com which threw up P1592 = rough road signal nothin else will try a new set of plugs
I tried unplugging each lead individually and didn't really notice a difference. New maf fitted this week sort of better low down but now takes a few goes to start it and revs drop really low and occasionally stall
 
palace said:
Right sorry to take so long. Getting. Back to you l have a nano-com which threw up P1592 = rough road signal nothin else will try a new set of plugs
I tried unplugging each lead individually and didn't really notice a difference. New maf fitted this week sort of better low down but now takes a few goes to start it and revs drop really low and occasionally stall
Click to expand...
Where did you get the new MAF from. Anything other than genuine Bosch will probably be worse than the original it replaced.
 
Right changed the maf put on new coil packs ( that was fun ) still no power at all any ideas I do have a nanocom but don't really have much luck with it
 
if it was a manual i would say slipping clutch......have you check your sparks to each lead? Id start thinking about your drive train
 
Don't think drive train as it sounds rough too though I am getting the abs and traction lights on no brake light though
 
You must log in or register to reply here.

Similar threads

F
P38 DSE loss of power when driving
2
Replies
33
Views
2K
Mark Piercy
Mark Piercy
JT_spark
P38 DSE Auto intermittent lack of power after vehicle has been hot
Replies
8
Views
537
brianp38dse
brianp38dse
tweedandbriar
Flat Spot at low revs...
Replies
4
Views
339
tweedandbriar
tweedandbriar
M
Sporadic lack of power at very low speed
Replies
6
Views
454
Meerkat1234
M
kermit_rr
L322 Tdv8 cruise control issue
Replies
13
Views
733
kermit_rr
kermit_rr
Back
Top