Disco 2 New Idler Pulley Play

Disco-Skipper

Active Member

Posts

87

Location

Wales

• Aug 30, 2021

• #1

Hi All

Do the bearings in new idlers 'bed in' at all?

I've put some new ones on and as the video shows they've got a load of side to side movement in them - I made sure to install them exactly as the old ones came off. I can feel that the play is in the bearing as the inner race moves independently of the wheel by hand



I'm having the issue with both ERR6949 and ERR6658 which came from JGS 4x4 - is it worth getting in contact with their customer services and trying to talk my way into a replacement?

Thanks for your help as usual

 

NPG

Well-Known Member

Posts

455

Location

Ireland

• Aug 31, 2021

• #2

That doesn't look right and I wouldn't put it into service. I changed mine with a genuine part (less the mounting bracket) and it was a tight fit.

 

Disco-Skipper

Active Member

Posts

87

Location

Wales

• Aug 31, 2021

• #3

Looks like I'd better see if I can get replacements then, thanks for the second opinion

 

Last edited: Aug 31, 2021

kermit_rr

Very

Full Member

Posts

33,601

Location

North Shropshire

• Aug 31, 2021

• #4

Doesn't look good to me

 

Disco-Skipper

Active Member

Posts

87

Location

Wales

• Aug 31, 2021

• #5

I'll let you know how I get on with replacements - I've had good experiences with JGS in the past so will hopefully be easy enough

 

Hellastony

Active Member

Posts

244

Location

Essex and Pelion, Greece

• Aug 31, 2021

• #6

This is another part that it is worth replacing with an original LR item. They usually last at least 100k miles, (replaced mine at 120k, as it was squeaking when cold), so worth the money IMO.

 

JUKE179r

Well-Known Member

Posts

3,166

Location

Suffolkshire

• Sep 2, 2021

• #7

I noticed the same on my V8’s 80mm idler pulley (#PQR500060).
It had play when I wiggled it even though it was only 2 years old. I bought another new 80mm idler pulley and it had the same amount of play. Ugh.

 

Disco-Skipper

Active Member

Posts

87

Location

Wales

• Sep 3, 2021

• #8

Who'd have thought it was that hard to make a bearing with passable tolerances!

I've been in contact with JGS and there is a pair of replacements in the post already no questions asked so I'll give them credit for that

I've had it in and out so many times I've now managed to pull the thread out of the casting for the water pump, so I've got to go down the route of helicoiling it which should be fun...

Does anyone know the specs for the bolt (ERR5958) to help me source the right helicoil? The usual googling has come up with nothing as far as I can see

Cheers

 

Disco-Skipper

Active Member

Posts

87

Location

Wales

• Sep 3, 2021

• #9

Just been out with a ruler and it looks like an M10 x 1.5 to me