Nanocom won't boot when connected to car

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
mickwall

mickwall

Active Member
Posts
109
Location
Croydon
Hi all

I have been diagnosing a Missfire so connecting the nanocom on and off for a bit. Finally got the missfire sorted but on the last attempt to check all the live data when I connected the nanocome to the socket it stays "dead". If I connect the nanocom to the PC via USB it works. Any suggestions?

Thanks
 
Sorry to hijack this thread, but i may have a similar misfire problem, not really sure as it's only a feeling that something's not quite right.

I've got a nanocom and seeing your post about monitoring the live data and identifying a misfire on cyl 6, thought that would be much easier than pulling plugs to identify the culprit, so plugged it in, but I can't find where in the various menus (seem to have tried them all) it gives live data for the engine.

Can you give me a clue? (4.6 HSE GEMS by the way)

TIA Alastair.
 
I have the Thor motronic. For me just went to the motronic menu then roughness option. I'll see if I can get screen shots.
 
Thanks Mick, but I've just been on the nanocom forum and I suspect that Gems won't report in such detail as the THOR which has something called 'crank wheel adaption, Phase 1-4' for misfire detection.

Ho hum - back to the traditional way then . . .

Glad yours is sorted now.

A
 
You must log in or register to reply here.

Similar threads

F
2001 P38 2.5 Diesel EKA Via NANOCOM
2
Replies
35
Views
2K
Datatek
Datatek
M
P38A Finally have time to be back on forums again
Replies
4
Views
244
brianp38dse
brianp38dse
8v_chris
P38A EAS & Nanocom - not talking to each other!
2
Replies
28
Views
3K
8v_chris
8v_chris
ar1g3
P38A Bulb Failure message preconditions?
Replies
6
Views
598
Datatek
Datatek
Vagabondrobb
Disco 2 3 amigos with horn
Replies
13
Views
808
Vagabondrobb
Vagabondrobb
Back
Top