nanocom with td5

hello all,i am currently converting a nas d2 v8 auto to a td5 manual.got the install 80% complete.fuel press near 5 bar while cranking and running for 1sec,new ckp sensor,new injector washers and o rings,new injector harness.

i am looking to match my nas bcu to a td5 ecu.with the bcu to ecu wire disconnected the engine will start and run for 1 second and then die.if the wire is connected the engine will crank but not start.
so my question is will nanocom mobilize the security?i should buy one if i continue to do these conversions any way.
also is there a way to bypass the immobilization feature in the ecu
thanks
brett

hi, i dont know any method to bypass the immobiliser, the best is to synk' it with the BCU via nanocom or hawkeye... in the engine management programmng - immobiliser menu you have to prompt "learn security code" for that but that's not enough cos you have to 'customise' the BCU too by setting it to diesel and manual, etc. so you deffinitely need a tester

thanks for the info i have a nanocom coming.
brett

Where did you get the Nanocom from?