Motorway ride height took forever to settle.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

Musicmaker

Active Member
Posts
346
Location
Glasgow, Scotland
Went for a run today and noticed that the motorway ride height did not light up or adjust down, just kept on standard. Beforehand it always dropped after 30 seconds. However, after about 20 minutes the Mway indicator lit up, but I never felt it dropping as I normally do. So I locked it, then checked the heights when I got home. The rear wheels were around 445mm but the fronts were sitting at 480 mm. I thought maybe a NRV was not working, but it dropped to access mode OK. Will need to try the EASlock software to see if I can adjust them. Using this software, is it possible to reset to RR default settings, or is it a case of change the numbers on the software and measure the wheels?

Billy
 
Went for a run today and noticed that the motorway ride height did not light up or adjust down, just kept on standard. Beforehand it always dropped after 30 seconds. However, after about 20 minutes the Mway indicator lit up, but I never felt it dropping as I normally do. So I locked it, then checked the heights when I got home. The rear wheels were around 445mm but the fronts were sitting at 480 mm. I thought maybe a NRV was not working, but it dropped to access mode OK. Will need to try the EASlock software to see if I can adjust them. Using this software, is it possible to reset to RR default settings, or is it a case of change the numbers on the software and measure the wheels?

Billy

None of the three NRVs control ride height, only air flow within the system.
 
could it not be the driver pack playing silly buggers due to the heat build up in the box mine did a similar thing then i drilled holes in the box lid and its not done it since dont think that outside temp in the high 20s plus the heat from the box helps much mind
 
could it not be the driver pack playing silly buggers due to the heat build up in the box mine did a similar thing then i drilled holes in the box lid and its not done it since dont think that outside temp in the high 20s plus the heat from the box helps much mind

Don't know, possible as it has never done this before and maybe the speed I was doing cooled it down :) Anyway, think i'll wait till later as it's too bloody warm to work on it :eek:
 
Back
Top