steve2286w
Well-Known Member
- Posts
- 4,596
- Location
- monkeyangerland
Have to get it sorted soon before snow gets too deep
Missing reverse
- Thread starter tottot
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
tottot
Well-Known Member
- Posts
- 8,106
- Location
- west wales coast
. However the last time we had any real snow [2018] someone left this in the only road out. I did pull it out but the very next day a Transit was stuck in the same place! 
steve2286w
Well-Known Member
- Posts
- 4,596
- Location
- monkeyangerland
Feck I’m not surprised can only see the poles!
tottot
Well-Known Member
- Posts
- 8,106
- Location
- west wales coast
Aww crap, crap parts that is. Fitted the syncro detent springs put the unit on the shaft and did a by hand test. Straight away one pinged out, put it back and did the same again with another half way out.
In pic is the one survivor from original above next to replacement below. Have ordered some LR original.
In pic is the one survivor from original above next to replacement below. Have ordered some LR original.
Attachments
steve2286w
Well-Known Member
- Posts
- 4,596
- Location
- monkeyangerland
They just bent? Hopefully lr ones do the job, holds you up though
tottot
Well-Known Member
- Posts
- 8,106
- Location
- west wales coast
They are spring steel so have to be set right before temper, an attempt to put right would result in weakening or just snap.
steve2286w
Well-Known Member
- Posts
- 4,596
- Location
- monkeyangerland
As a challenge while,waiting for new ones you could try the annealing , bending , hardening and tempering , prob just need water and oil
tottot
Well-Known Member
- Posts
- 8,106
- Location
- west wales coast
When one compares to original [ zoom in ] one can see the shape is all wrong and ends to short so will not bother with them.
tottot
Well-Known Member
- Posts
- 8,106
- Location
- west wales coast
Still trying to get original syncro detent springs, anyone know where?
DeviousLandyGod
Active Member
- Posts
- 122
- Location
- Leicester
Had some in back order for months at Craddocks… they just refunded me as there is any available it seems..
I have used a complete new Bearmach unit, so might have some on my old unit if you are welcome to… I’ll have a look if interested..
I have used a complete new Bearmach unit, so might have some on my old unit if you are welcome to… I’ll have a look if interested..
tottot
Well-Known Member
- Posts
- 8,106
- Location
- west wales coast
Hi, Same issue here with Craddocks. Yes interested. Message sent.
tottot
Well-Known Member
- Posts
- 8,106
- Location
- west wales coast
Just an up date on this long saga. In March had a run in with a long cold and then seasonal work and other repairs had to come first. Still box has been back together a couple of months now and works as it should turning by hand. Transfer got a clean out and new seals/gaskets and ready to mate up. Now where are the nuts and bolts? 
