Missing multiplugs on engine harness

brianconwy · Dec 18, 2019

Another problem with the loom that came with the engine I bought. Not only are the connectors for the EGR modulator missing, but there are also two multiplugs missing that connect to the engine compartment fusebox. Shown above. What are these for and are they essential?

brianconwy · Dec 18, 2019

They seem to be connectors C0570 and C0571.

sierrafery · Dec 19, 2019

So just confirm you bought a harness for a D2 Td5 and you are sure it's not a Defendser loom ?... don't rely on scrappers cos they don't care, for them a Td5 is just a lump, they have no ideea about differencies

brianconwy · Dec 19, 2019

I bought an engine and the harness is the one that came with the engine. I still have my original harness. Would I be better just using my original harness? If the engine was from a defender then would it still work with my loom and ECU? Thanks.

sierrafery · Dec 19, 2019

Yes, the engine will work with your ECU as long as it's the same(10P or 15+P) and the injector codes are saved in the ECU... also if you are not sure that the engine was removed from a D2 (and it seems it wasnt based on the lack of some plugs) better use the original D2's harness

brianconwy · Dec 19, 2019

Thanks for that. The injectors are from the original engine and put back in the same order. I will use the original harness. The glow plug connectors were damaged on removal. Parts of the shrouds are missing on some. Is that likely to cause any major problems?

sierrafery · Dec 19, 2019

As long as you take some action to keep clean and tight contacts in all connectors it should be OK

Missing multiplugs on engine harness

brianconwy

Well-Known Member

brianconwy

Well-Known Member

sierrafery

Well-Known Member

brianconwy

Well-Known Member

sierrafery

Well-Known Member

brianconwy

Well-Known Member

sierrafery

Well-Known Member

Similar threads