norseman
Well-Known Member
- Posts
- 3,259
- Location
- Essex - UK
I've been having problems with my 3.5efi misfiring, always at low speed. Initially suspecting ignition system problems I've so far replaced the ign. module (now remote via link lead) coil, spark plugs & leads. The replacement dizzy cap & rotor arm (in green Lucas boxes) were of such poor quality that I cleaned & reused my existing 'made in UK' items.
The car runs fine for the majority of the time, even when I floor it through the kick-down, but will occasionally loose power & 'stumble' a low speed, picking up again when throttle is opened. In a worse case scenario, stopping & giving the old girl a good revving will restore all power. Some journeys can be completed without a hint of trouble, even cruising at the legal limit.
2 suggestions have been made by friends, firstly the usage of supermarket fuel could be a contributory factor (I have always pumped E5 protection grade since this E10 rubbish came onto the market) & to that end I put 40 litres of BP Ultimate in the tank yesterday.
The second suggestion was to spray a suitable aerosol cleaner into the AFM with the engine running in order to cure a possible sticking flap when the air flow is low, as it would be at low RPM. To this end I considered removing the air cleaner trumpet & filter & spraying into the empty filter casing.
Any advice or comments would be appreciated guys, many thanks.
The car runs fine for the majority of the time, even when I floor it through the kick-down, but will occasionally loose power & 'stumble' a low speed, picking up again when throttle is opened. In a worse case scenario, stopping & giving the old girl a good revving will restore all power. Some journeys can be completed without a hint of trouble, even cruising at the legal limit.
2 suggestions have been made by friends, firstly the usage of supermarket fuel could be a contributory factor (I have always pumped E5 protection grade since this E10 rubbish came onto the market) & to that end I put 40 litres of BP Ultimate in the tank yesterday.
The second suggestion was to spray a suitable aerosol cleaner into the AFM with the engine running in order to cure a possible sticking flap when the air flow is low, as it would be at low RPM. To this end I considered removing the air cleaner trumpet & filter & spraying into the empty filter casing.
Any advice or comments would be appreciated guys, many thanks.