Mini restoration of my 75 Series 3
- Thread starter norried
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
tottot
Well-Known Member
- Posts
- 8,031
- Location
- west wales coast
Looking well nice.
Huddy84
Well-Known Member
- Posts
- 746
- Location
- East Anglia
Looking lovely
well I've been prepping the front wings for paint today. I've split the outer wings away from the inner wings. I got 2 used wings which were better nick that the ones that were on mine. However after rubbing one down it was full of filler on the top so I am using one of my original inner wings. I had to make up a couple of repair panels. I cut one of the skins off my old Defender doors and used that as a repair panel.
Norrie
Norrie
Rubins4
Well-Known Member
- Posts
- 813
Rubins4
Well-Known Member
- Posts
- 813
Like it. how/where/why/howmuch
Is that the only way to go electronic? i thought there might be an alternative where you swap out the points in the original distributor? Any links to generic advice welcomed.
Powerspark from eBay. £75 for the dizzy and leads. £17 for the coil.
I'm sure there are other ways to go but this is the way I have gone. Started the engine fine afterwards.. However decided to remove the carb afterwards to reseal it and the spacer broke so haven't set the timing or anything yet. Decided on a new carb as well so will update after I've renewed that and set everything up.
Norrie.
I'm sure there are other ways to go but this is the way I have gone. Started the engine fine afterwards.. However decided to remove the carb afterwards to reseal it and the spacer broke so haven't set the timing or anything yet. Decided on a new carb as well so will update after I've renewed that and set everything up.
Norrie.
