So I’m a total amateur who’s trying to change a cylinder head. I’ve found top dead centre, I’ve locked the camshaft. When I crawled under to lock the flywheel there’s no “notch” to lock the flywheel. I’ve got two coloured links on the timing chain with the groove between them what am I doing wrong?
Locking the flywheel
- Thread starter Twinnie
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
markomate2
Well-Known Member
- Posts
- 899
- Location
- Bedford and Tallinn
Do you have the correct size locking pin?
You may need to rotate the engine back n forth slightly before the pin locates.
I'm pretty sure when I did the head swap that I didn't bother locking the flywheel, but maybe that's just my memory!
You may need to rotate the engine back n forth slightly before the pin locates.
I'm pretty sure when I did the head swap that I didn't bother locking the flywheel, but maybe that's just my memory!
I’m assuming the locking pin is the right size. It’s not something I fabricated, I bought the tool with my new cylinder head from Turner Engineering. Ive looked inside and it just looks like a flat piece of metal. I think I’m just going to put it in gear and go for it now I’ve finally go the sockets to take those big inside bolts off, whatever they’re called. Surely if I put it in gear it isn’t going to move?
Interceptorxj
Well-Known Member
- Posts
- 1,718
- Location
- Bolton, Greater Manchester.
deleted
Last edited:
Interceptorxj
Well-Known Member
- Posts
- 1,718
- Location
- Bolton, Greater Manchester.
Sleep depravation!
Was just about to say you need to change that
J
Shows how much I know.
