Series 3 Location of accelerator bracket holes

Hi folks,
After almost finishing welding up my bulkhead I realised that I have plugwelded up the bracket holes for the accelerator crosshaft. The two brackets that are mounted on the top corners.
i can see roughly where they go but I don't know how accurate i need to be when re-drilling new holes.
Any advice or measurements on that one?

cheers peter

Are they mirror image of the passenger side?

Hi Phil,
Both my brackets are identical with holes going at 45 degrees roughly . My holes are welded up and have been ground over.
I saw a couple of photos online which showed both bracket holes going in the same direction.
chhers peter
it is just the position of them I need.