Knackered steering box.......

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Posts
26
Location
Hampshire
Hi all

Have started a rebuild project - photos can be seen here - https://www.landyzone.co.uk/land-rover/1998-lhd-300tdi-rebuild.358488/

The steering box is close to kaput -

20200407_111612.jpg


Lots of play and leaking like a sieve.

Under normal circumstances, I would probably order a refurbished one (Adwest??), but with the current lock down getting parts sipped to my part of the world (Southern Europe) is proving challenging.

So what are my options?

- Leave it on and replace at a later stage?
- any temp fixes people can suggest?

Thanks
 
  • Like
Reactions: 8ha
As v8250 said, it can be rebuilt. The main shaft may need machining though. Where I come from we rebuild boxes all the time but in most instances, a simple re-kit will not do the job. We'll have to have the shaft machined.
 
How will putting new seals in remove play?


It wont but if there is no play a set of seals can sort it. Given the mess all over the box it looks like something at the top of the box or even above it is leaking.
A good clean up and then see where the leek is and check for movement in the output shaft.
 
  • Like
Reactions: 8ha
Have you tried to adjust the box? I thought I was gonna need a new one. Managed to adjust all the play out of it. That and a new seal could keep you going for along time. Look up on adjusting it. There's a few steps to do. Can only be done with the steering straight. Hope you can sort it.

Cheers Steve
 
  • Like
Reactions: 8ha
Thanks for all the suggestions. Will be taking a closer look next week when i can get back in the workshop and see if anything can be done. Worse case, I have found a scrap yard with 4 x 300 TDI's, so will go and pull buts from them.
 
Back
Top