Kingpin repair - non ABS

The Mad Hat Man · Jul 5, 2015

I have some play in the OS king pin. is it worth just removing a shim, or is it worth replacing both top & bottom bearings? Is it worth doing the other side (no play) or just do the one side?

It looks like a bit of a bugger to replace both bearings... is it?

chrisstdt · Jul 5, 2015

Try removing shims (if there are any left) if theres still plenty grease left the bearing should be fine

If you do end up replacing the bearings you have to strip down the hub

RichP · Jul 5, 2015

I'd just remove a shim/shims and see whether that gets rid of any play before rebuilding the whole thing.

The Mad Hat Man · Jul 6, 2015

will give that a try - ta

The Mad Hat Man · Jul 7, 2015

part update....

Always check the wheel bearing first

:doh:.

i was convinced the problem was the king pins, as I couldnt detect any play horizontally, only vertically.

Having removed 15thou of shims, I could still detect almost the same amount of play, so thought I would check the wheel bearing. Although the tabs were present, the outer nut had slackened slightly and this enabled the inner to move about 1/4 of a flat. Nipped them both up again and the play had gone.

Just got to check the shims in the top king pin again and X fingers.

The Mad Hat Man · Jul 12, 2015

replaced all the shims one by one until i had all the original shims back in - no play....

check the wheel bearings first.

Kingpin repair - non ABS

The Mad Hat Man

Well-Known Member

chrisstdt

Well-Known Member

RichP

Active Member

The Mad Hat Man

Well-Known Member

The Mad Hat Man

Well-Known Member

The Mad Hat Man

Well-Known Member

Similar threads