kenlowe fans

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
just bin out and tried 1, wire it 1 way and blows air the fan side and swap wires around and blows air the motor side of the fan! :confused:
 
im a little confused! lol if i wire them so air is pulled though the fan it shouldnt matter if their 1 side or the other side of rad? wot i was asking is wots best for cooling?:confused:
 
It depends entirely :rolleyes: on the fan design. Whether yu push or pull doesn't matter. Theoretically pulling air through us better, but lots of manufactures put fans in front of the rad. It is more important to fit the biggest fan possible.
 
1 got 2 at about 12ins so that should be ok just thought it would be better 2 push cold air from outside than pull hot air from engine bay?
 
1 got 2 at about 12ins so that should be ok just thought it would be better 2 push cold air from outside than pull hot air from engine bay?

I may have misunderstood your post but you can't pull hot air from the engine bay through the rad'.

You must drive air from front to back (of the vehicle) regardless of whether the fans push or pull they must move air in the right direction, or you could end up fighting the natural air flow caused by the vehicle moving forward and end up with little or no effective flow and an overheated engine.
 
I may have misunderstood your post but you can't pull hot air from the engine bay through the rad'.

You must drive air from front to back (of the vehicle) regardless of whether the fans push or pull they must move air in the right direction, or you could end up fighting the natural air flow caused by the vehicle moving forward and end up with little or no effective flow and an overheated engine.

Exactly. the air has to go from in front of the rad towards the engine.
 
Back
Top