P38A Is this the head gasket?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
E

EntropyUK

Well-Known Member
Posts
467
Location
Hemel Hempsted
Hi all, long time no speak. I am looking for your opinion on a problem I have with my Diesel.

About a week and a half ago my Rangie suddenly became difficult to start. Lots of cranking until a cylinder or two start to catch then carry on until the revs pick up.

I have assumed that the glow plugs have failed and have a set on hand. I am going to fit glow plugs regardless.

Looking over the engine I noticed that it has drunk quite a bit of coolant with about a third of the header tank coolant gone. Looked at the oil filler and dipstick but no sign at all of emulsion.

I am now worried that the sudden difficulty starting is lack of compression rather than glow plugs.

Is this the end of of my big blue legend?
 
EntropyUK said:
Hi all, long time no speak. I am looking for your opinion on a problem I have with my Diesel.

About a week and a half ago my Rangie suddenly became difficult to start. Lots of cranking until a cylinder or two start to catch then carry on until the revs pick up.

I have assumed that the glow plugs have failed and have a set on hand. I am going to fit glow plugs regardless.

Looking over the engine I noticed that it has drunk quite a bit of coolant with about a third of the header tank coolant gone. Looked at the oil filler and dipstick but no sign at all of emulsion.

I am now worried that the sudden difficulty starting is lack of compression rather than glow plugs.

Is this the end of of my big blue legend?
Click to expand...
HGF is rare on the M51, coolant loss is much more likely to be a leak, is the underlay wet in the drivers footwell? Hard starting from cold is usually glow plugs, hope you have good quality replacements, the cheapo's don't work. If new glow plugs don't fix it, check the voltage at the glow plugs, if you still have a problem and have diagnostics, check the EDC temperature sensor. If that is OK do a compression test. If the compression is down on a cylinder, it's more likely to be a cracked head then HGF but I doubt that is the problem.
 
I've had a few cold starting issues, the first couple were a persistent leak from number one injector spill pipe, check, when cold, that no air bubbles are present in the curly clear pipe to the fip whilst someone else cranks her over. Diesel in the injector well is a sure sign too but do check for bubbles. If there are bubbles then air is getting in and fuel is running back, spill lines are the usual culprit but rusty fuel tank connections can be another.
I've also had the coolent loss thing as well, if you stick your finger in the footwell vent from the heater...is it wet?
 
EntropyUK said:
The same for the Beru ones I had on hand. Plus I lost one as it dropped into the engine somewhere. no amount of searching could find it.
Click to expand...
I've lost 2 heater plug nuts, an inlet manifold nut, a valve block collet and a 4mm hex key in the engine bay! Never found any of them, hex key was a surprise as it was so big but mirror on a stick and a torch couldn't locate it.
Oh, and a new airspring O ring somewhere down there a day ago too.
 
Flossie said:
I've lost 2 heater plug nuts, an inlet manifold nut, a valve block collet and a 4mm hex key in the engine bay! Never found any of them, hex key was a surprise as it was so big but mirror on a stick and a torch couldn't locate it.
Oh, and a new airspring O ring somewhere down there a day ago too.
Click to expand...
I dropped the screeenwash filler cap several years ago & can still see it stuck & inaccessible. I just bought a replacement. I might just be able to reach it if I had one of those but grabber thingies where you press a button at the top to use the fingers at the end.
 
nigelbb said:
I dropped the screeenwash filler cap several years ago & can still see it stuck & inaccessible. I just bought a replacement. I might just be able to reach it if I had one of those but grabber thingies where you press a button at the top to use the fingers at the end.
Click to expand...
Have a look on Amazon, they are full of stuff like that👍
 
You must log in or register to reply here.

Similar threads

B
Restored 1972 Series 2 Diesel not starting
Replies
16
Views
549
Shedload
S
stuu
P38A Brands advice/suggestions
Replies
4
Views
642
stuu
stuu
L
Sport Glow plug light
Replies
6
Views
892
lj5000
L
N
Military 2.5d NA Head Gasket and Coolant Refill
Replies
3
Views
749
tottot
tottot
A
P38A Head Gasket Kit & ARP Bolts ?
2
Replies
23
Views
854
enjoi
enjoi
Back
Top